Interstellar Sliding Technique

Interstellar Sliding Technique

Sliding is the most advanced form of interstellar travel Sliding is the ability of traveling to a destination with the use of an image or picture the way this is done firstly we must choose an image after we have selected the image then we visualize the image using tele-visualization and the we project the visual upon a surface ie. like a wall or floor.

The reason for this technology is because while mapping the galaxies and planetary systems we found that teleportation had a time delay of around 5 to 10 seconds per 40 thousand light years and that teleportation was a matter of hit and miss in a lot of cases This is not to say that teleportation is messy it is my opinion that teleportation is the best form of travel but for mapping we need a system that makes it easy the flow that is why we have made the planetary data file system and the interstellar galaxy id card system Like the image below

You will find these cards throughout the constellation section of the site And as you can see the Name, Type, distance, size, and Magnitude are all on the card but on some of the older cards you will need to place your constellation upon the cards the newer card and cards in the future will carry the constellation information on the detail side of the card.

Interstellar Sliding Technique

VISUAL EXERCISE 1

STEP ONE
Get Comfortable and relax.

STEP TWO
Now i want you to focus on the image below and in your own time close your eyes and visualize this card with your minds eye.

 

STEP THREE
Now when you have a clear image of the interstellar card i want you to project the image upon the surface of a wall or floor.

STEP FOUR
Then i want you to visualize that your visual body is standing in front of the image upon the wall or floor and prepare your visual body for interstellar travel with an interstellar protection shield.

STEP FIVE
Then i want you to project energy from the right hand on your visual body and see that energy blending with the image and till the image is covered with a thin layer of energy.

STEP SIX
Now i want you to focus on the red arrow on the image this red arrow is your destination in galaxy M88 in the virgo constellation. Now at this point i would like to remind you that this is an image of this galaxy but when you teleport into the image you will be in that galaxy. So make sure if you end up in the way of a planetary body orbiting around in that galaxy teleport to safety.

STEP SEVEN
Then i your own time teleport into the image and take care and when you arrive cloak the doorway of the sliding technique with an energy cloak from the porthole section.

STEP EIGHT
Then perform an interstellar planetary detection rapid to check to see if there are any planets in this galaxy and if there are then teleport to the nearest planetary destination to you in that planetary system.

STEP NINE
Once you arrive on the surface of the planet perform an atmospheric composition Scan and a Core Comparison Scan and when you have contemplated your data file move on to the next planetary body in that planetary system.

STEP TEN
When you have finished with the mapping of that planetary system teleport back to the doorway and remove the cloak and teleport back through to your planetary system in the meridian system.

STEP ELEVEN
Then in your own time open your eyes and take notes of your planetary data file and write them down.

DESTINATION: Your Choice

VISUAL EXERCISE 2

STEP ONE
Get Comfortable and relax.

STEP TWO
Now i want you to focus and in your own time close your eyes and visualize that there is a class disk in front of you with your minds eye.

STEP THREE
Now when you have a clear image of the disk i want you to project the image upon the surface of a wall or floor.

STEP FOUR
Then i want you to visualize that your visual body is standing in front of the image upon the wall or floor and prepare your visual body for interstellar travel with an interstellar protection shield.

STEP FIVE
Then i want you to project energy from the right hand on your visual body and see that energy blending with the image and till the image is covered with a thin layer of energy.

STEP SIX
Now i want you to focus on your destination in galaxy ____ in the ____ constellation.  Make sure if you end up in the way of a planetary body orbiting around in that galaxy teleport to safety.

STEP SEVEN
Then i your own time teleport into the image and take care and when you arrive cloak the doorway of the sliding technique with an energy cloak from the porthole section.

STEP EIGHT
Then perform an interstellar planetary detection rapid to check to see if there are any planets in this galaxy and if there are then teleport to the nearest planetary destination to you in that planetary system.

STEP NINE
Once you arrive on the surface of the planet perform an atmospheric composition Scan and a Core Comparison Scan and when you have contemplated your data file move on to the next planetary body in that planetary system.

STEP TEN
When you have finished with the mapping of that planetary system teleport back to the doorway and remove the cloak and teleport back through to your planetary system in the meridian system.

STEP ELEVEN
Then in your own time open your eyes and take notes of your planetary data file and write them down.